Each of these characteristics is displayed in the corresponding indicator color: There are four options for displaying the parameters of the hard disk in the Crystal Disk Info program: “good”, “attention”, “bad” and “unknown”. The program displays both technical information (disk name, volume, temperature, etc.) and S.M.A.R.T.-analysis data. But even with this option, it is enough to perform the advanced search of disks once, so that with all the next program starts, information about the hard drive is displayed immediately. The only exceptions are those cases that were mentioned above. View Drive InformationĪctually, all information about the hard drive on which the operating system is installed, opens immediately after the program starts. To do this, go to the menu section - “Service”, select “Advanced” in the list that appears, and then “Advanced disk search”.Īfter performing this procedure, the disk, as well as information about it, should appear in the main program window. Complaints about the program begin.īut, in fact, detecting a disk is quite simple. Naturally, this causes bewilderment among users, because the computer cannot work with a completely faulty hard drive. In this case, all data on the disk will be completely empty. Let's see how to use CrystalDiskInfo.Īfter starting the utility, on some computers, it is possible that the following message will be displayed in the CrystalDiskInfo program window: “Disk not detected”. This application performs in-depth S.M.A.R.T.-analysis of disks, but at the same time, some users complain about the confusion of managing this utility. Among the many utilities that provide information about the hard drive, CrystalDiskInfo is characterized by a large amount of output data. The condition of the computer’s hard drive is a very important factor in the system’s performance.

Crystaldiskinfo apm greyed out